Skip to content
⁨NDDev RnD⁩, home page
Community
Language: English
Display
Theme
Motion

Software development for machines and equipment

NDDev writes software for machine tools and industrial equipment: communication through the equipment's own protocols and APIs, measurement capture and processing, operator interfaces and data export to your business systems. We work with the equipment already on your shop floor. For Traktorodetal we made measurements of the required product range five times faster; the project is under NDA.

Who it is for

Plants, workshops and equipment suppliers that need the software side of machine tools, measuring lines and test rigs.

  • Communication with machines and sensors
  • Operator interfaces in Qt
  • Measurement processing in C++ and Rust
  • Built around your equipment

Where our part of the work lies

The machine, the sensors and the electronics stay with the equipment manufacturer. We write the software around them: communication through the protocols and APIs the equipment already supports, measurement capture and checks, calculations, operator interfaces and data transfer to business systems. The client provides the equipment and secure access to it.

  • a review of the equipment's documentation and protocols
  • software for machine communication and data capture
  • measurement checks and cleaning
  • an operator interface for the shop floor
  • model inference on existing hardware
  • data transfer to business and production systems
  • documentation and an administrator guide

Code that runs next to the machine and has to keep pace with it is written in C++17/20/23 and Rust and built with CMake or Meson. Desktop interfaces for the shop floor are built in Qt. Data analysis is written in Python, and models that must run on the device itself are converted to ONNX and TensorRT.

How the software reaches the shop floor

We work in sprints of one to two weeks and show you every version.

  1. Survey

    We study the equipment, its documentation and protocols, and agree secure access to it.

  2. Connection check

    Before the main contract we test communication with the machine and the quality of the data it produces.

  3. Specification and build

    We fix the requirements in a specification, write the software and test each version on your equipment.

  4. Shop-floor launch

    We install the software at the workstations, show operators how to use it and hand over the documentation.

Work in this area

  • HarvesterLib

    A C++20 library for Traktorodetal: it processes log diameter and length measurements from forestry harvesters and works out trunk width from them. With it, measuring the required product range runs five times faster.

Questions from manufacturers about equipment software

Do you develop electronics and firmware?

Our part is software: communication, data processing, interfaces and integrations. Boards, circuits and firmware that carry liability for the electronic product stay with the equipment manufacturer, and we work with them through their documentation and protocols.

Can you connect to an older machine?

If the machine has a communication protocol or a data output, we start with a check: what data it produces and how often. We give our conclusion on the connection after that check, before the main contract.

What did you do for Traktorodetal?

The HarvesterLib library: it works out trunk width from forestry harvester measurements, and measuring the required product range runs five times faster.

How much does development cost?

The cost depends on the number of machines and protocols, the volume of data processing and the number of interfaces. The starting price is shown in the price block on this page. We fix the total in the specification, and writing it is part of the project price.

Will we have to stop production?

We test and develop on a rig or on a dedicated machine, so the software reaches the shop floor already tested. The launch slot on the line is agreed with you in advance.

from $6,700

Free warranty
60 days

Prices are starting prices for information only and are not a public offer. The final price is fixed in the specification.

Software for equipment and industry

Tell us about the machine and what it needs to do

Send the equipment model, its documentation or a description of the task. We will tell you where the check should start.

We reply within 24 hours

Assistant

Loading the assistant…